A how-to guide from Unclog.itWritten by a Red Seal plumber in British Columbia

Plunger · 5 to 10 minutes · Updated November 2026

How to plunge a toilet.

Most clogs clear with a plunger. Most people still do it wrong: wrong plunger, a cup full of air, and too much speed. Here is the version that works.

Start with the right plunger

Flange plungerThe one you want. The extra sleeve on the bottom folds out and seals a toilet's drain. Good for most toilets and standard clogs.
Cup plungerMade for sinks and flat drains. It gets a poor seal on a toilet.
Accordion plungerHigh pressure for stubborn clogs, but harder to use and it splashes back.

Before you start: water off at the wall, gloves and eye protection on, and the bowl about half full. Too full and it splashes; too empty and there is no water to push. The five set-up steps.

The eight steps

  1. A plunger with the flange folded out, and one with it tucked in, crossed out

    Check the plunger. The flange should be folded out, not tucked up inside the cup.

  2. A plunger being lowered into the toilet bowl

    Lower the plunger into the bowl slowly so it doesn't splash.

  3. The plunger cup pressed against the bowl to push out air

    Press the cup against the bowl to push the air out. Air compresses and water doesn't, so a cup full of water pushes harder.

  4. The plunger cup sealed over the drain opening

    Line the cup up with the drain and get a full seal.

  5. The plunger being pushed down and pulled back

    Push down and pull back slowly, keeping the seal. You should feel suction.

  6. Plunging continued over several cycles

    Keep going for several cycles. Seal and control matter more than speed.

  7. Pull the plunger away and see if the bowl drains. Try up to 3 rounds.

  8. A toilet auger, the next tool to try

    Still clogged after 3 rounds? Move on to a toilet auger.

    Andrew's pro tip: If it didn't clear, skip the rage flush and try the auger.

Why it works

A plunger does not push the clog with rubber. It pushes water. Water does not compress, so a cup full of water sends the whole stroke down into the trap. A cup full of air just squashes. That is why the air comes out first and the seal matters more than speed.

Andrew's pro tip: Air is bad. Air compresses, water doesn't.

If it still won't clear

Three proper rounds with no change means it is not a plunger clog. Skip the rage flush and move on to the toilet auger.

Questions

Can I use a sink plunger on a toilet?

It gets a poor seal. A flat cup plunger is made for sinks and flat drains. A flange plunger has an extra sleeve that fits the toilet's drain opening.

How many times should I plunge?

Several slow cycles make one round, then pull the plunger away and see if the bowl drains. Try up to three rounds. After that, switch to a toilet auger.

Should I flush to test it?

Not with the bowl full. Watch whether the bowl drains on its own first. A flush on a toilet that is still blocked sends a tank of water into it with nowhere to go.

More toilet help

This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.