A how-to guide from Unclog.itWritten by a Red Seal plumber in British Columbia

Toilet auger · 10 minutes · Updated November 2026

How to use a toilet auger.

A toilet auger is a short cable on a crank, with a guard that protects the bowl. It reaches past the trap, the tightest bend in the toilet, and breaks up or hooks what a plunger can't move.

When to reach for it

After the plungerThree proper rounds with a flange plunger and the bowl still won't drain.
When something went inA toy, a toothbrush, a deodorant cap or a wad of wipes. An auger hooks or breaks up what suction can't shift.
Straight awayPlumbers often skip the plunger and start here. It clears most stubborn clogs without taking the toilet off the floor.

Before you start: water off at the wall, gloves and eye protection on, and the bowl bailed down enough to work without splashing. The five set-up steps.

The seven steps

  1. Unclip the auger head and pull the handle up until the head sits just outside the tube.

  2. The auger guard resting in the bowl, angled into the drain

    Set the guard in the bowl and angle it into the drain. The guard is what protects the porcelain.

    Andrew's pro tip: The porcelain glaze on a toilet can scratch permanently. Keep the guard seated and avoid metal-on-porcelain contact.

  3. Hold the grip and turn the crank slowly while pushing the cable toward the drain.

  4. An auger head curled back into the bowl, crossed out

    Check that the head hasn't curled back into the bowl. Keep the guard seated.

    Andrew's pro tip: If the cable loops back into the bowl you can scar the surface or kink the cable. Keep light tension and watch your angle.

  5. Keep turning and feeding until the handles meet again.

  6. Pull the auger back out and see if the bowl drains. Try up to 3 passes.

  7. A toilet that is still clogged after the auger

    Still clogged? The toilet may need to come off the floor. That's the point to call a plumber.

If it still won't clear

Three passes with no change means the blockage is past the reach of the auger, or something is lodged that has to be taken out from below. Either way the toilet may need to come off the floor, and that is the point to call a plumber. Forcing it risks cracking the porcelain or damaging the flange.

Questions

Will a toilet auger scratch the bowl?

Not if the guard stays seated in the bowl. The scratches come from the bare cable or head touching the porcelain, which happens when the guard lifts out or the cable loops back.

Is a toilet auger the same as a drain snake?

No. A toilet auger is short and has a guard made for the bowl. A drain snake for sinks and tubs has no guard and will mark the porcelain.

More toilet help

This page is general information, not professional advice for your situation. If you are unsure at any point, stop and call a licensed plumber. See the legal disclaimer.